Saturday Night Racer

Saturday Night Racer
http://www.latemodelracer.com/cgi-bin/yabb2/YaBB.pl
Saturday Night Racer >> CLASSIFIEDS >> Need a reverse rotation SBC roller cam
http://www.latemodelracer.com/cgi-bin/yabb2/YaBB.pl?num=1235806946

Message started by Rod_Rothgarn on 02/27/09 at 11:42pm

Title: Need a reverse rotation SBC roller cam
Post by Rod_Rothgarn on 02/27/09 at 11:42pm

One of those old 505 Isky grinds would be sweet. Anything 260-ish @ .050 would be nice. A bigger, grindable core will work to.

Thanks,
Rodney
559 307 6785

Title: Re: Need a reverse rotation SBC roller cam
Post by TIM_BEWLEY on 02/28/09 at 10:00am

what do you run for a distributor? i have a rr solid lift cam. i really like it but it ruins the hei housings because it is pulling the shaft down instead of up. mine is a delong. check this site out maybe this guy can help. thanks

http://www.geocities.com/delongcams/

Title: Re: Need a reverse rotation SBC roller cam
Post by hogracer3d on 02/28/09 at 12:44pm

Prestolite makes (or at least used to ) a RR electronic distributor for the port engine of a twin engine marine application

Title: Re: Need a reverse rotation SBC roller cam
Post by Rod_Rothgarn on 02/28/09 at 7:15pm

TIM_BEWLEY wrote on 02/28/09 at 10:00am:

Thanks for the reply. I use Super 2 or sprint mags. Never really had a housing issue, but then again I never watched for it. I have a flat-tappet motor I want to put in a car that requires the oil, fuel and steering pumps be ran off the cam and have the gear drive for a reverse cam that the morons forgot to steal when they stole my cam.

It's either find a cam on the cheap, start making losta brackets for belt drives (rather not), or not put that motor in that car at all. No rush. Just something I'd like to do at some point.

Title: Re: Need a reverse rotation SBC roller cam
Post by Rod_Rothgarn on 03/12/09 at 10:37pm

Still lookin'. No big deal. just keep an eye out please. Or if you find one that needs a gear drive, I have a used one or I can send you to a guy with a new drive.

Thanks again.