Saturday Night Racer

Saturday Night Racer
http://www.latemodelracer.com/cgi-bin/yabb2/YaBB.pl
Saturday Night Racer >> RACE TECH >> just a thought on lower trailing arms of a sport mod
http://www.latemodelracer.com/cgi-bin/yabb2/YaBB.pl?num=1393283273

Message started by CaliforniaPickle14B on 02/24/14 at 3:07pm

Title: just a thought on lower trailing arms of a sport mod
Post by CaliforniaPickle14B on 02/24/14 at 3:07pm

Just a thought

Now on A mods they use floating bridcages so they roate for the 4 bar set up and get the car to hike.

Now on all the sport mods i seen so far we all run the lower trailing arm mount at the bottom of the reared housing snout art the centerline of the tube. What if we was to put a mount in the front of the rear end and raised the chassis mount to get the right angle, this would avoid the bar from binding in the instance that the car did get enough lift and didn't button out on the under slung. Any thoughts or had anyone tried this in any mods?

Title: Re: just a thought on lower trailing arms of a sport mod
Post by 4QChris on 02/24/14 at 11:02pm

Shaw already has something very similar. Kind of at a forty five degree angle from the axle center line. Don't run much angle with it

Title: Re: just a thought on lower trailing arms of a sport mod
Post by CaliforniaPickle14B on 02/25/14 at 12:48pm

Hmm well if shaw has this set up i guess i go see what they have done with it thanks for your reply

Title: Re: just a thought on lower trailing arms of a sport mod
Post by XMODRACER on 04/02/14 at 12:33pm

I believe what yur talking bout is called a hillbillie bird cage , think I remember kellon chadwick ran this on one of his pro chassis, if I remember right hillbillie right , two link under on lefy and pullbar on top. :D

Title: Re: just a thought on lower trailing arms of a sport mod
Post by DeltaGraphix on 08/12/14 at 2:55pm

XMODRACER wrote on 04/02/14 at 12:33pm:

That was the standard mount for the Pro and it was only used for the spring mount and the shock.